Load Display Objects
Load fields are often placed close to the loads on the oneline to indicate their MW/Mvar value.
Run Mode
When animation is active, the flow of the arrows into the load is proportional to its current MW load. You can customize the appearance of this flow using the Animated Flows Tab of the Oneline Display Options Dialog.
Right clicking on a load (bus) field gives you the option to open the Load Field Dialog or the Load Dialog.
Edit Mode
To add a new load to the case, select Network > Load from Individual Insert ribbon group on the Draw ribbon tab. Then, select the bus to which you want to attach the load with the left mouse button. This calls up the Load Dialog. The bus number is automatically determined from the bus to which you attached the load. The ID field contains a two-character ID used to distinguish multiple loads at a bus. The default ID is 1.
Enter the size, the thickness of the lines [in pixels] used to display the device, the orientation, and the base MW and Mvar load values for the device. Usually, only the Constant Power fields are specified as nonzero. The Constant Current and Constant Impedance fields are used to specify loads that vary with voltage. Constant current loads vary proportionally with bus voltage, while constant impedance loads vary with the square of the voltage. Specify the constant current and constant impedance values assuming one per-unit voltage.
Select OK to add the load. If you do not want to add the load to the case, select Cancel.
To modify the parameters for an existing load, position the cursor on the load and right-click. Select Load Information Dialog from the local menu to invoke the Load Dialog. You can then change any parameter as desired. You can select from the Formatting ribbon group on the Draw ribbon tab to change the drawing parameters of the load.