See Also
To access the Flows and Voltages Sensitivities dialog go to the Tools ribbon tab, and choose Sensitivities > Flows and Voltages Sensitivities from the Run Mode ribbon group. This is only available in Run Mode.
The grids that occupy all of the tabs on this dialog list each device of the particular type in the system, subject to the Area/Zone/Owner Filter settings. These grids are case information displays, and thus share properties and controls common to all other case information displays.
This dialog is split up into 5 separate tabs allowing the calculation of various sensitivity combinations. These tabs are as follows and separate help topics are written for each tab.
- Single Meter, Multiple Transfers
- Single Transfer, Multiple Meters
- Self Sensitivity
- Multiple Meters, Single Control Change
- Multiple Meters, Multiple Control Changes
Click Close to close the Flows and Voltages Dialog.