See Also
These options are all available on the Contingency Analysis Dialog under the Contingency Options Tab under the Limit Monitoring grouping. In general all the Limit Monitoring Settings specified with the case are used to determine what is eligible for monitoring. These settings can all be seen by clicking the Limit Monitoring Settings button. Other contingency-analysis specific limit monitoring settings are configured on this section as follows
- Advanced Limit Monitoring : the options on this page allow you to configure limit monitoring depending on how the value changes in relation to the reference case value.
- Island Monitoring: Added in Version 20the options on this page allow you to configure whether to report limit violations based on unsolved islands or islands that do not have enough MW Reserves
- Monitoring Exceptions : the options on this page allow you to configure exceptions to the normal Limit Monitoring Settings. Exceptions may cause a line to be included or excluded.
- Custom Monitors : the options on this page allow you to configure objects and associated fields to be monitored during a contingency analysis run in addition to the devices that are monitored using the Limit Monitoring Settings.
- When using Integrated Topology Processing, monitor only the primary bus for each superbus : checking this box will reduce the repeated bus voltage limit violation that would appear for buses at the same super bus. This box is checked by default. In addition to monitoring the primary bus for each super bus, the bus with the highest low voltage limit and the bus with the lowest high voltage limit will also be monitored so as not to miss any possible violations.