Series Capacitor Field Options Dialog

See Also

 

Series capacitor field display objects are used to show field values specific to series capacitors on onelines. Use Line Fields to show fields generic to transformers, series capacitors and transmission lines, such as the flow of power through the device.

This dialog can be opened by right-clicking on a series capacitor display field and choosing to open the Line Field Information Dialog while in run mode. If in edit mode this dialog will be opened simply by right-clicking on a series capacitor display field.

The series capacitor field options dialog is used to view and modify the parameters associated with series capacitor specific fields.

 

Near Bus Number

Bus associated with the near end of the series capacitor.

Far Bus Number

Bus associated with the far end of the series capacitor.

Circuit

Two-character identifier used to distinguish between branches joining the same two buses. Default is '1'.

Anchored

When checked, the text field will move with the series capacitor if the series capacitor is moved on the oneline diagram.

Total Digits in Field

Total number of digits to show in the field.

Digits to Right of Decimal

Number of digits to show to the right of the decimal point.

Rotation Angle in Degrees

The angle at which the text will be placed.

Field Value

The value of the currently selected field.

Field Prefix

A prefix that can be specified and displayed with the selected value.

Include Suffix

If this checkbox is checked, the corresponding field units will be displayed after the current value. Otherwise, only the value without units will be shown.

Type of Field

Used to determine the type of series capacitor field to show. The following choices are available:

Status 

Status of the series capacitor.

Series Capacitance 

Per unit impedance of series capacitor.

 

Select OK to save changes and close the dialog or Cancel to close dialog without saving your changes.