Fault Analysis
Fault analysis can only be performed when Simulator is in Run Mode. There are three ways to start a fault analysis study:
- Go to the Tools ribbon tab, and choose Fault Analysis from the Run Mode ribbon group. This is only available in Run Mode.
- Right click on a bus and choose Fault… to perform a fault analysis at that bus
- Right click on a line and choose Fault… to perform a fault analysis at that point on the line
All of these options will open the Fault Analysis dialog. If you opened the dialog by right-clicking on a bus or line, the fault information on that bus or line will already be filled in. If you selected the Fault Analysis… option from the Tools ribbon tab, the information about the location of the fault will need to be provided.